WEBUI connect with OLM3 for LightBurn

How does the Laser Explorer connect with OLM3? Reading WEBUI connect with OLM3 for LightBurn 2 minutes
  1. Open the LightBurn and connect to the machine
    In the console:

Enter the code; "$74=WIFI name" (for example: $74=ottest24g), and click Enterdisplay OK indicates the setting success

Enter the code; "$75=WIFI password" (for example: $75=test1234), and then click Enter, display OK indicates the setting success.

Finally, enter the code: "$WRS", and then click Enter, display OK indicates successful setting.The $WRS code is simply understood as a refresh.Refrefresh can obtain an IP address.

Open the browser, enter the website bar, enter the IP address obtained above, such as "192.168.124.9", and then click Enter

Enter the default account: "admin", the default password: "admin", and enter the operation interface

1.)Ggode files required to make web control engraving in LightBurn software

Import the pictures that you need to engrave, and set the engraving parameters, and finally click “OK”

(2)Click Save Program, save as to. End with nc suffix to U disk (this U disk is TF card on the machine)

3Select the G-Gode file in the webUI

Wait to upload...

  1. Select the file required to be engraved

 

As indicated, the laser module was focused.The distance after focus is the best distance between the laser module and the engraved surface

Manually move the laser module to the start position of the engraving and click "Next" to the next step

Set the number of engraving, generally is the default 1 times.Then click the "Start" button to the next step.

2. Click "run" to start carving

3.Thank you !

Leave a comment

All comments are moderated before being published.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.