Comparison Between Ortur Laser Master 3 and Others

Machine	Ortur Laser Master 3	Others
Engraving Speed	Over 20000mm/min	Not more than 9000mm/min, once more than 9000mm/min, the machine will carve abnormal (may not have problems for a short time, once a large area or a long time a little carving will appear)
Security	emergency stop switch and safety use key	There is no emergency stop switch and safety use key, which does not comply with safety regulations and is dangerous for laser engraving machines.

Flame detection device	The machine will stop immediately	Keeps alarming, no real effect.
Wire Harness	Running properly	It will cut the machine and affect the normal engraving.
grayscale	ORTUR machine engraving effect is excellent in the industry.	Engraving imaging grayscale is almost no gray transition
Motion Components	Covered. It's safe.	All exposed, it will lead to machine movement damage and will lead to easy oil contamination.
Control Board	Covered. It's safe.	All exposed, easy to cause a short circuit in the line is not waterproof, electrocution, etc.
Motherboard Firmware	OLM3 supports changes for greater operational freedom.	Does not support changing any parameters
Software	LaserGRBL；LightBurn；Laser APP for mobiles	Some machines do not support LaserGRBL, a mainstream foreign engraving software, and are semi-compatible with LightBurn.
manufacturers	Compatible with accessories from other manufacturers.	Partially incompatible.
APP	Once it is set up, you can continue to use it next time.	Every time once you set up the engraving, you have to go to the machine and click on that big round button before the engraving will start.