AlgoLaser DIY KIT 10W&5W Diode Laser Engraver

Wood, acrylic, bamboo, cloth (not cotton, canvas works best), leather, kraft paper, hard plastic, black lacquered metal/ceramic/stone, glass (need to be blacked out), food

Cardboard, Felt, Stickers, Wood, Acrylic, Bamboo, Cloth, Kraft, Hard Plastic, Leather.

Maximum cutting thickness: black acrylic( 12mm) wood board(20mm).Both of them require multiple engravings.

Yes, the ORTUR laser can cut PCB boards made of acetate. preferably black or green

You can cut opaque mirrored acrylic. Transparent materials cannot be cut and can only be engraved after blackening

It can engrave the metal after electroplating or spraying (for coating or oxide layer), stainless steel (the effect of stainless steel is better after blackening, note: not etching, but discoloration)

The laser can engrave on the glass surface, but the engraving depth is not deep and cannot be cut. Glass engraving is usually difficult to control. You can make a smoother frosted surface by following the steps below: Paste thermal paper on the area to be engraved, and place it on the engraved area to flatten it without wrinkles. Put the glass in the engraving machine to engrave, then remove the glass, tear off the thermal paper, and clean the glass surface. There are other ways to engrave glass on YOUTUBE, such as first layer paint engraving and then wipe off, the engraving effect is very good.